Heat
Feeling and seeing temperature changesWithin some reasonable temperature range, we can get a rough idea how warm something is by touching it. But this can be unreliable—if you put one hand in cold water, one in hot, then plunge both of them into lukewarm water, one hand will tell you it’s hot, the other will feel cold. For something too hot to touch, we can often get an impression of how hot it is by approaching and sensing the radiant heat. If the temperature increases enough, it begins to glow and we can see it’s hot!
The problem with these subjective perceptions of heat is that they may not be the same for everybody. If our two hands can’t agree on whether water is warm or cold, how likely is it that a group of people can set a uniform standard? We need to construct a device of some kind that responds to temperature in a simple, measurable way—we need a thermometer.
The first step on the road to a thermometer was taken by one Philo of Byzantium, an engineer, in the second century BC. He took a hollow lead sphere connected with a tight seal to one end of a pipe, the other end of the pipe being under water in another vessel.
To quote Philo: “…if you expose the sphere to the sun, part of the air enclosed in the tube will pass out when the sphere becomes hot. This will be evident because the air will descend from the tube into the water, agitating it and producing a succession of bubbles.
Now if the sphere is put back in the shade, that is, where the sun’s rays do not reach it, the water will rise and pass through the tube …”
“No matter how many times you repeat the operation, the same thing will happen.
In fact, if you heat the sphere with fire, or even if you pour hot water over it, the result will be the same.”
Notice that Philo did what a real investigative scientist should do—he checked that the experiment was reproducible, and he established that the air’s expansion was in response to heat being applied to the sphere, and was independent of the source of the heat.
Classic Dramatic Uses of Temperature-Dependent Effects
This expansion of air on heating became widely known in classical times, and was used in various dramatic devices. For example, Hero of Alexandria describes a small temple where a fire on the altar causes the doors to open
Still, none of these ingenious devices is a thermometer. There was no attempt (at least none recorded) by Philo or his followers to make a quantitative measurement of how hot or cold the sphere was. And the “meter” in thermometer means measurement
The First Thermometer
Galileo claimed to have invented the first thermometer. Well, actually, he called it a thermoscope, but he did try to measure “degrees of heat and cold” according to a colleague, and that qualifies it as a thermometer. (Technically, a thermoscope is a device making it possible to see a temperature change, a thermometer can measure the temperature change.) Galileo used an inverted narrow-necked bulb with a tubular neck, like a hen’s egg with a long glass tube attached at the tip.
He first heated the bulb with his hands then immediately put it into water. He recorded that the water rose in the bulb the height of “one palm”. Later, either Galileo or his colleague Santorio Santorio put a paper scale next to the tube to read off changes in the water level. This definitely made it a thermometer, but who thought of it first isn’t clear (they argued about it). And, in fact, this thermometer had problems.
Question: what problems? If you occasionally top up the water, why shouldn’t this thermometer be good for recording daily changes in temperature?
Answer: because it’s also a barometer! But—Galileo didn’t know about the atmospheric pressure.
Torricelli, one of Galileo’s pupils, was the first to realize, shortly after Galileo died, that the real driving force in suction was external atmospheric pressure, a satisfying mechanical explanation in contrast to the philosophical “nature abhors a vacuum”. In the 1640’s, Pascal pointed out that the variability of atmospheric pressure rendered the air thermometer untrustworthy.
Liquid-in-glass thermometers were used from the 1630’s, and they were of course insensitive to barometric pressure. Meteorological records were kept from this time, but there was no real uniformity of temperature measurement until Fahrenheit, almost a hundred years later.
Question: what problems? If you occasionally top up the water, why shouldn’t this thermometer be good for recording daily changes in temperature?
Answer: because it’s also a barometer! But—Galileo didn’t know about the atmospheric pressure.
Torricelli, one of Galileo’s pupils, was the first to realize, shortly after Galileo died, that the real driving force in suction was external atmospheric pressure, a satisfying mechanical explanation in contrast to the philosophical “nature abhors a vacuum”. In the 1640’s, Pascal pointed out that the variability of atmospheric pressure rendered the air thermometer untrustworthy.
Liquid-in-glass thermometers were used from the 1630’s, and they were of course insensitive to barometric pressure. Meteorological records were kept from this time, but there was no real uniformity of temperature measurement until Fahrenheit, almost a hundred years later.
Newton’s Anonymous Table of Temperatures
The first systematic account of a range of different temperatures, “Degrees of Heat”, was written by Newton, but published anonymously, in 1701. Presumably he felt that this project lacked the timeless significance of some of his other achievements.
Taking the freezing point of water as zero, Newton found the temperature of boiling water to be almost three times that of the human body, melting lead eight times as great (actually 327C, whereas 8x37=296, so this is pretty good!) but for higher temperatures, such as that of a wood fire, he underestimated considerably. He used a linseed oil liquid in glass thermometer up to the melting point of tin (232°C). (Linseed oil doesn’t boil until 343°C, but that is also its autoignition temperature!)
Newton tried to estimate the higher temperatures indirectly. He heated up a piece of iron in a fire, then let it cool in a steady breeze. He found that, at least at the lower temperatures where he could cross check with his thermometer, the temperature dropped in a geometric progression, that is, if it took five minutes to drop from 80° above air temperature to 40° above air temperature, it took another five minutes to drop to 20° above air, another five to drop to 10° above, and so on. He then assumed this same pattern of temperature drop was true at the high temperatures beyond the reach of his thermometer, and so estimated the temperature of the fire and of iron glowing red hot. This wasn’t very accurate—he (under)estimated the temperature of the fire to be about 600°C.
Fahrenheit’s Excellent Thermometer
The first really good thermometer, using mercury expanding from a bulb into a capillary tube, was made by Fahrenheit in the early 1720’s. He got the idea of using mercury from a colleague’s comment that one should correct a barometer reading to allow for the variation of the density of mercury with temperature. The point that has to be borne in mind in constructing thermometers, and defining temperature scales, is that not all liquids expand at uniform rates on heating—water, for example, at first contracts on heating from its freezing point, then begins to expand at around forty degrees Fahrenheit, so a water thermometer wouldn’t be very helpful on a cold day. It is also not easy to manufacture a uniform cross section capillary tube, but Fahrenheit managed to do it, and demonstrated his success by showing his thermometers agreed with each other over a whole range of temperatures. Fortunately, it turns out that mercury is well behaved in that the temperature scale defined by taking its expansion to be uniform coincides very closely with the true temperature scale, as we shall see later.
Amontons’ Air Thermometer: Pressure Increases Linearly with Temperature
A little earlier (1702) Amontons introduced an air pressure thermometer. He established that if air at atmospheric pressure (he states 30 inches of mercury) at the freezing point of water is enclosed then heated to the boiling point of water, but meanwhile kept at constant volume by increasing the pressure on it, the pressure goes up by about 10 inches of mercury. He also discovered that if he compressed the air in the first place, so that it was at a pressure of sixty inches of mercury at the temperature of melting ice, then if he raised its temperature to that of boiling water, at the same time adding mercury to the column to keep the volume of air constant, the pressure increased by 20 inches of mercury. In other words, he found that for a fixed amount of air kept in a container at constant volume, the pressure increased with temperature by about 33% from freezing to boiling, that percentage being independent of the initial pressure.
The first systematic account of a range of different temperatures, “Degrees of Heat”, was written by Newton, but published anonymously, in 1701. Presumably he felt that this project lacked the timeless significance of some of his other achievements.
Taking the freezing point of water as zero, Newton found the temperature of boiling water to be almost three times that of the human body, melting lead eight times as great (actually 327C, whereas 8x37=296, so this is pretty good!) but for higher temperatures, such as that of a wood fire, he underestimated considerably. He used a linseed oil liquid in glass thermometer up to the melting point of tin (232°C). (Linseed oil doesn’t boil until 343°C, but that is also its autoignition temperature!)
Newton tried to estimate the higher temperatures indirectly. He heated up a piece of iron in a fire, then let it cool in a steady breeze. He found that, at least at the lower temperatures where he could cross check with his thermometer, the temperature dropped in a geometric progression, that is, if it took five minutes to drop from 80° above air temperature to 40° above air temperature, it took another five minutes to drop to 20° above air, another five to drop to 10° above, and so on. He then assumed this same pattern of temperature drop was true at the high temperatures beyond the reach of his thermometer, and so estimated the temperature of the fire and of iron glowing red hot. This wasn’t very accurate—he (under)estimated the temperature of the fire to be about 600°C.
Fahrenheit’s Excellent Thermometer
The first really good thermometer, using mercury expanding from a bulb into a capillary tube, was made by Fahrenheit in the early 1720’s. He got the idea of using mercury from a colleague’s comment that one should correct a barometer reading to allow for the variation of the density of mercury with temperature. The point that has to be borne in mind in constructing thermometers, and defining temperature scales, is that not all liquids expand at uniform rates on heating—water, for example, at first contracts on heating from its freezing point, then begins to expand at around forty degrees Fahrenheit, so a water thermometer wouldn’t be very helpful on a cold day. It is also not easy to manufacture a uniform cross section capillary tube, but Fahrenheit managed to do it, and demonstrated his success by showing his thermometers agreed with each other over a whole range of temperatures. Fortunately, it turns out that mercury is well behaved in that the temperature scale defined by taking its expansion to be uniform coincides very closely with the true temperature scale, as we shall see later.
Amontons’ Air Thermometer: Pressure Increases Linearly with Temperature
A little earlier (1702) Amontons introduced an air pressure thermometer. He established that if air at atmospheric pressure (he states 30 inches of mercury) at the freezing point of water is enclosed then heated to the boiling point of water, but meanwhile kept at constant volume by increasing the pressure on it, the pressure goes up by about 10 inches of mercury. He also discovered that if he compressed the air in the first place, so that it was at a pressure of sixty inches of mercury at the temperature of melting ice, then if he raised its temperature to that of boiling water, at the same time adding mercury to the column to keep the volume of air constant, the pressure increased by 20 inches of mercury. In other words, he found that for a fixed amount of air kept in a container at constant volume, the pressure increased with temperature by about 33% from freezing to boiling, that percentage being independent of the initial pressure.
No comments:
Post a Comment